Thank you in advance if you are able to help. the ability to capture and post settings somehow? Not sure how to post my settings, perhaps that would be a good feature of the software in future. I'm using a flashforge creator pro dual head printer, and trying to print with the roll of ABS that came in the box. Would welcome feedback on these settings to help minimise warping. print bed is 110, reduced to 85 after 10 layers. This box is also warping a little off the bed in the corners.
I am ok printing in PLA, but finding ABS is tougher. this one was ABS at 230, but a little research i did said I should go up to 260. again, its not a random miss, it appears to be a pattern that is not the same as the preview.Īny clues? Is it something to do with an equation of width or something? Any help or clue would be appreciated, first time i have come across something not coming out the way it looks on screen.Īs far as the splitting goes, I will try again, at a higher temp. It is supposed to be solid, and appears that way in s3d when I prepare to print, but doesn't actually lay it down that way.
If you look at the bottom of the box, some of the lines of filament are not getting laid down. So the missing filament is one I can't understand and would appreciate help with. Find specific lines relating to retraction and zhop, replacing them with comments this site expects to find and. So I am trying to print a basic box for a control plate in ABS. This gcode is instead provided by the site.
0 kommentar(er)
